Automatic door
operator shall be electromechanical, and provide for both powered
opening and powered closing of a door. The door opener shall provide no
influence upon the door except when it is actively involved with powered
opening, holding open, or closing, thus allowing unencumbered manual
operation.
The unit shall contain aninternal battery power supply to provide
powered operation in the event of external power failure. The unit shall
be powered by 24 vac, external to the device under provisions of low
voltage wiring and is supplied with a 40 VA transformer requiring 115
vac 60 Hz service.
The operator shall be mounted according to drawings and instructions
provided with each unit. The unit shall be capable of mounting on either
door or lintel and shall provide door opening angles up to 180 degrees.
The unit shall possess an adjustable hold-open feature allowing the door
between 5 and 60 seconds for passage. The unit shall stop when
encountering an obstruction during an operating cycle at which time it
ceases to provide an influence on the door.
Operation
Electro-mechanical. Power open, power close. Automatic clutch
disengagement at all times when not activated, allowing unimpeded manual
operation.
|
Automatic
open-hold-close cycle (5 to 60 seconds) activated by a signal from
internal radio receiver or the momentary closure of electrical contacts
provided by wires to unit.
Automatic cycle may be interrupted by a signal received within the cycle
bringing the operator into a disengaged state. Door may be closed
remotely if door is found left open in a non-active state upon receipt
of a signal.
Optional Mode (Auto-Close setting) - Causes door to close automatically
after a delay upon manual opening. Can be brought into activation in one
of three ways:
1. Provision of electrical wires to unit to provide a discontinuity
between internal contacts.
2. Provision of discontinuity of contacts upon installation.
3. Removal of 24 vac external power to operator.
Electrical Specifications
Operator:
16-24 vac/dc, 0.01 amp
Wall Transformer:
Input - 115 vac, 60 Hz
Output - 24 vac, 0.03 amp
Battery:
12V DC, 1.2Ah lead acid gel cell
Motor:
12V DC, 1.5A
Clutch:
12V DC, 0.5A
|
Supply for
Unlatching Device:
12V DC, 1A
Radio Receiver:
19,683 Security Combinations (Programmable)
Dimensions:
2 5/8” x 14 1/8” (Suitable for mounting with perpendicular wall
close to door frame.)
Weight:
10 Lbs.
Material/Finish:
Steel housing
Painted aluminum finish #25
Physical Applications:
Door mounted for inward and outward opening doors in either
right-hand or left-hand hinged configurations. (Ceiling clearance 1 1/4”
minimum between door and ceiling). Lintel mounted for inward and outward
opening doors in either right-hand or left-hand hinged configurations.
Activation
Activation may occur by coded signal
from transmitter or by wireless security entry system. Activation
contacts are provided within unit for remote wired activation from any
device providing momentary continuity such as touch
plates, push plates,
mats, or infrared motion sensors.
________________________
Warranty
Open Sesame Operators and controls are
covered by a one year limited warranty on materials and internal
workmanship. Our warranty does not apply to services performed during
installation but technical assistance is available by calling 1-866-465-4387
________________________ |
